Salda Stouch Notice Technique page 30

EN
User menu
In order to reach user menu, press down B2 and B3 for 3 seconds.
In user menu, menu items (P.01, P.02 etc.) settings are displayed sequentially. Menu item is selected using
elements B4 and B6. After pressing B5, value of selected parameter is shown and can be changed using ele-
ments B4 and B6. Press B5 to save the parameter and to return to menu.
Due to limitations of segment display, values of P.04 and P.05 are shown divided by 10, i.e. if 20 is displayed, it
means that real value is 20 x 10 = 200.
P.06 - To reset fi lter timer to press and hold for 5 seconds item B5. Also fi lter timer resets by removing A.03
alarm.
Touch element B1 to exit menu.
No.
P.01
P.02
Supply air temperature display 0: Not shown
P.03
P.04
P.05
P.06
Intended use
1) 1) Modbus maste
This controller can control other devices (controlled by MODBUS protocol). This can be set in service menu by
selecting required parameters for service menu items F.17, F.18, F.19, F.20, F.21. To control not only standard
devices, select "CUSTOM" in menu item F.20 and device addresses in menu items from F.22 up to F.37. If
devices have no such addresses, in fi elds of given menu items enter "00:00". Normally, this controller is used
with ECO or PRV control boards.
2) Modbus slave
Using BMS (Building Management System), several devices can be controlled simultaneously or one device
can be controlled using several controllers. MODBUS protocol allows changing all parameters of controllers and
monitoring data of connected sensors.
(slave)
30
Name Possible values
Sleep mode 0 - Off
Sound
CO2 required (ppm) 0 – 99 x10ppm
CO2 allowed difference 0 – 99 x10ppm
Filtrer timer 0 – 999 days
ster (main)
CONTROLLER
(master)
AHU AHU
(slave)
1 - 99 sleeping time in seconds
0: Off
1: 1 –9 sound tone
1: Shown interchangeably with the set temp
MODBUS
AHU
(slave)
BMS
CONTROLLER
(slave)
CONTROLLER
(slave)
www.salda.lt
Default
value
0
2
0
20 x10
5 x 10
0