Salda Stouch Notice Technique page 27

EN
Installation
Using provided template, at the intended location screw the self-threading screws leaving gap of approximately
1 mm from the plane.
2. Connect the cable to the controller
2.1- standard connection
PIN1 - +24V
1 4
PIN2 - B+
PIN3 - A-
PIN4 - COM
PIN1 - +24V
1 2 3 4
PIN2 - B+
PIN3 - A-
PIN4 - COM
2.2 - spec connection (see "8 pin connection").
3. Attach the controller by positioning it rotated to the left at the angle of 25°.
4-5. Turn the controller to the right until the controller contacts the plane. Remove the used template.
www.salda.lt
27