Salda Stouch Notice Technique page 28

EN
IT IS FORBIDDEN to leave the remaining remote controller's cable in the AHU's control box!
8 8 pin connection
Only competent electrician is allowed to make electrical connections in accordance with the applicable interna-
tional and national electrical safety and electrical equipment installation requirements.
1. Power supply 24V AC/DC, 100mA
2. Power supply 24V AC/DC
3. GND
4. RS485 B (Modbus)
5. RS485 A (Modbus)
6. GND
7. 0-10VDC input (used for pressure or CO2 sensor). The sensor is powered from a separate power source.
8. 0-10VDC output (used for control of 0..10 VDC fans.
Information
• Controller allows easy setting of sound, temperature, sleep mode and CO2 level parameters from the user
menu.
• Fast button for setting maximum speed.
• Numerical display of set and supply air temperature.
• Selected speed LED indication.
• Symbolical display of active alarms: A.01, A.02, etc., and LED indication.
• Controller sleep mode to reduce power consumption.
• Selectable ventilation system switch off locking feature.
• "Child safety feature" - locks the controller.
L1 L5 L6
B1
L4
S1
B6
28
on
for fo user
L2
L7
B5 B4
Description of elements
B1 On/Off
B2
B2 Fan speed selection
B3 Temperature selection
L3
B3
B4 Increase
Maximum fan speed for limited time
B5
(boost)
B6 Decrease
S1 Segment display
L4-L7 Fan speed indications
www.salda.lt