Operation - Dometic GROUP WAECO CoolMatic CSMP2 Instructions De Montage Et De Service

CoolMatic CSMP2
➤ Push the drawer back in (fig. b, page 4).
➤ Screw the lock tight again and put the panel back on.
➤ Fasten the board again and put the mattress back on.
✓ Installation is complete.
7

Operation

I
NOTE
Empty the cool box and switch it off before tilting the cab.
7.1 Before initial use
I
NOTE
Before starting your new cooler for the first time, you should clean
it inside and outside with a damp cloth for hygienic reasons (see
"Cleaning and care" on page 24).
7.2 Energy saving tips
 Allow hot food to cool down first before you place it into the device.
 Do not open the cooler more often than necessary.
 Do not leave the cooler open for longer than necessary.
 Avoid unnecessarily low temperature settings.
7.3 Using the cooler
A
NOTICE! Danger of overheating
Ensure at all times that there is sufficient ventilation so that the heat
that generated during operation can dissipate. Ensure that the ven-
tilation slots are not covered. Make sure that the device is suffi-
ciently far away from walls and other objects so that the air can
circulate.
EN
Operation
23