Installation And Connection - Dometic GROUP WAECO CoolMatic CSMP2 Instructions De Montage Et De Service

Installation and connection

5.2 Operating and display elements
No. in
fig. c,
Description
page 5
1 Temperature controller
6 Installation and connection
The cooler is installed in the drawer under the bed.
➤ Lift the mattress.
➤ Unscrew the four screws (fig. 1, page 3) and take off the board.
➤ Pull out the drawer and take out the container (fig. 2, page 3).
After you fit the cooler, you can put the container back in.
I
NOTE
If you cannot fully pull out the drawer, this is how to release it:
➤ Remove the screws (fig. 3 1, page 3) and unplug the panel beside the
drawer (fig. 3 2, page 3).
➤ Have the supply cable from slot X 7 (fig. 4, page 3) to the cooler laid by
a specialist Mercedes Benz garage.
➤ Cut out a section for ventilation at the appropriate position on the panel
(fig. 5, page 3)
➤ Push on the plate nuts supplied (fig. 6, page 3 and fig. 7, page 4)
➤ Feed the connection cable for the cooler through the hole provided.
(fig. 8, page 4)
➤ Fasten the cooler with the screws provided at the appropriate positions
(fig. 9, page 4).
➤ Fasten the cooler cable to the position marked on the drawer using the
clip provided and place the rubber in the appropriate position (fig. 0,
page 4).
➤ Have the cooler cable connected to the cable laid by the Mercedes Benz
garage from the fuse box behind the cover panel (fig. a, page 4).
22
Explanation
– Switches the cooler on or off
– Adjusts the temperature
CoolMatic CSMP2
EN