Recommissioning; Appliance Shutdown; Alternative Installation Methods - Stiebel Eltron DCE-S 6/8 Plus Utilisation Et Installation

iNSTallaTiON

appliance shutdown

f Hook the appliance cover into the appliance back panel at the
top rear. Pivot the appliance cover downwards. Check that
the appliance cover is securely seated both top and bottom.
f Secure the appliance cover with the screw.
f Remove the protective film from the user interface.
f Switch on the power supply.
f Ensure that the programming unit is functioning correctly.
f Turn the temperature selector to its left-hand and right-hand
end-stop.
10.3.1 Appliance handover
f Explain the appliance function to users and familiarise them
with how it works.
f Make the user aware of potential dangers, especially the risk
of scalding.
f Hand over the instructions.

10.4 Recommissioning

Material losses
!
To ensure that the bare wire heating system is not dam-
aged following an interruption to the water supply, the
appliance must be restarted by taking the following steps.
f Disconnect the appliance from the power supply by
removing the fuses/tripping the MCBs.
f Vent the appliance and the cold water inlet line (see
chapter "Commissioning / Initial start-up").
f Switch the power back ON.
11. Appliance shutdown
f Isolate all poles of the appliance from the power supply.
f Drain the appliance (see chapter "Maintenance / Draining the
appliance").
10 | DCE-S Plus

12. Alternative installation methods

WARNING Electrocution
Before performing any work on the appliance, discon-
nect all poles from the power supply.
12.1 Electrical connection from above on unfinished
walls
1 Cable grommet
2 Cable routing
f Break out the required aperture in the back panel for the
power cable (for positions, see chapter "Specification / Di-
mensions and connections"). Deburr any sharp edges with a
file.
f Cut a hole in the cable grommet to fit the selected connecting
cable. Fit the cable grommet.
f Reposition the mains terminal from the bottom to the top.
To do so, unclip the mains terminal by pushing it firmly to
the left and pulling it forwards. Turn the mains terminal with
connecting cables 180° clockwise. Lay the internal wiring
under the cable guide. Clip the mains terminal in by pushing
it inwards and to the left until it clicks into place.
f Install the appliance and connect the power cable to the
mains terminal as described in chapter "Installation / Stand-
ard installation on finished walls".
Note
Disconnecting the mains terminal at the top:
f Use a screwdriver to disengage the locking tab from
the right-hand side.
1
2
www.stiebel-eltron.com