Initial Start-Up; Appliance Handover; Recommissioning - Stiebel Eltron DNM 3 Utilisation Et Installation

INSTALLATION
Commissioning
11. Commissioning

11.1 Initial start-up

f Fill the appliance by running the tap several times until the f
pipework and appliance are free of air.
f Carry out a tightness check. f
f Insert the power cable plug, if present, into the standard f
safety socket or set the fuse/MCB.
f Check the function of the appliance. f
f In the case of oversink installation, affix the company logo f
supplied over the existing company logo.
38 | DNM

11.2 Appliance handover

f Explain the appliance function to users and familiarise them f
with its operation.
f Make users aware of potential dangers, especially the risk of f
scalding.
f Hand over these instructions. f

11.3 Recommissioning

Material losses
!
Following an interruption of the water supply, recommis-
sion the appliance by carrying out the following steps,
in order to prevent irreparable damage to the bare wire
heating system.
f Isolate the appliance from the power supply. Pull the power f
cable plug, if present, from the socket, or remove the fuse/
reset the MCB.
f See chapter "Initial start-up". f
www.stiebel-eltron.com