SATA 3000 K spray mix Mode D'emploi page 39

Operating instructions SATAjet 3000 K spray mix
Remove the pre-nozzle, hard metal ball tip and paint needle
■ Unscrew pre-nozzle [8-4] using the SATA universal spanner.
■ Unscrew end screw [8-8] using Allen key.
■ Remove the spring [8-7].
■ Unscrew hard metal ball tip (spanner size 4) [8-5] using SATA spanner
(holding the end of the needle firmly with a screwdriver).
■ Remove paint needle [8-6].
Fit a new pre-nozzle, hard metal ball tip and paint needle
Damage from incorrect installation sequence
The components can be damaged if fitted in the wrong order.
→ Heed correct installation sequence.
■ Insert new paint needle [8-6].
■ Screw the new hard metal ball tip [8-5] onto the paint needle using the
spanner (holding the end of the needle firmly with a screwdriver).
■ Push paint needle to the back.
■ Screw in the new pre-nozzle [8-4] using the SATA universal spanner.
■ Position the spring [8-7].
■ Screw on end screw [8-8] using Allen key.
Mount a new material nozzle
Insert the pre-nozzle in the air cap for material nozzles with reversing
switch. Pay attention to the groove alignment with the fixing pin.
■ Insert material nozzle [3-3] in air cap [3-2]. Pay attention to the groove
alignment with the fixing pin.
■ Position air cap ring with contact protection [3-1] together with air cap
and material nozzle, then screw on by hand.
10.2. Replacing the air distribution ring
Replacing the air distribution ring must be preceded and followed by the
steps required for replacing the nozzle parts (see chapter 10.1).
Dismantle the air distribution ring
Attention!
Note!
EN
39