Videotec UPTIRN Manuel D'instructions page 6

6 Installation
This product can be installed only on the
ULISSE P&T line. For installation and setting
please refer to the P&T manual.
6.3.1 Description of the LED illuminator
• Twilight sensor: Detects the light level.
• Cable: Power supply and control.
• Switch-on threshold regulator: The
potentiometer allows adjusting the sensitivity
threshold to switch on the illuminator.
• Infrared power control: The potentiometer allows
adjusting the power of the illuminator.
Twilight sensor
Switch-on threshold
regulator
Fig. 1
4
Cable
Infrared power
control
7 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE) mandates
that these devices should not be disposed of in the
normal flow of municipal solid waste, but they should
be collected separately in order to optimize the
recovery stream and recycling of the materials that
they contain and to reduce the impact on human
health and the environment due to the presence of
potentially hazardous substances.
The symbol of the crossed out bin is marked
on all products to remember this.
The waste may be delivered to appropriate collection
centers, or may be delivered free of charge to the
distributor where you purchased the equipment at
the time of purchase of a new equivalent or without
obligation to a new purchase for equipment with size
smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.
MNVKUPTIRN_2222_EN