ESTEBAN PARIS EASY MIST Notice D'utilisation page 9

REPAIR
If the product is not working properly, check the following points:
Problems / Symptoms
No mist when the
appliance is switched on
e
Mist stops while the
diffuser is in operation
Insufficient mist
The light does not
switch on
Should the problems persist please contact your retailer.
The manufacturer is not responsible for damages caused by improper use of the diffuser.
sks
gent
with
ng.
Causes
The appliance is not plugged in
Water level too low
Water level exceeds 200 ml
The end of part A is obstructed
Water level too low
Accumulation of water drops in the part A
The ceramic disk is dirty
An excess of Estéban refresher oils or
essential oils has been poured into the
container
Accumulation of water drops in the part A
Water level exceeds 200 ml
Diffuser failure
Solutions
Make sure that the power adapter is properly connected
to the appliance and fully plugged in to the wall socket
Fill the water container
Empty out excess water
Make sure that nothing is preventing the release of the
mist
Fill the water container
Switch off the diffuser, remove part A then clean off the
accumulated water drops
Clean the ceramic disk as described in the
« PRECAUTION FOR USE » instructions
Empty the appliance and clean it
Switch off the diffuser, remove part A then clean off the
accumulated water drops
Empty out excess water
Bring the diffuser back to the retailer within
the after-sales service support legal deadline
9