Transport, Storage And Packaging - oventrop Regudis W-HTU Duo Mode D'emploi

NOTICE
According to the DVGW work sheet W551,
dwelling stations are small installations if the pipe
content of each potable water pipe behind the
station does not exceed 3 litres. As a result, the
following pipe lengths for copper and stainless
steel pipes must not be exceeded:
d [mm] d
a
DN 10 12
DN 12 15
DN 15 18
DN 20 22
DN 25 28
2.5 Temperature settings
NOTICE
When leaving the factory, the potable water
temperature is set to approx. 50 °C (position 3 at
the temperature controller).
The system temperatures must comply with the
legal requirements.
Especially when operating a circulation system, it
must be ensured that a temperature of 55 °C is
not undercut at any point of the pipework.
WARNING
High system temperatures may enhance corrosion
and the formation of calcium deposits. The
specifying engineer and the user of the system are
responsible to evaluate these factors and to take
preventive measures if required (e.g. water
treatment).
WARNING
Risk of scalding Outlet temperatures exceeding
43 °C can lead to scalding.
[mm] V/L [l/m] l [m]
i max
10 0.08 37.9
13 0.13 22.6
16 0.20 14.9
20 0.31 9.5
25 0.49 6.1
3 Transport, storage and
packaging
3.1 Transport inspection
Upon receipt check delivery for any damages caused
during transit.
Any damage must be reported immediately upon
receipt.
1
Illustr. 3.1 Extent of supply
1. Dwelling station
2. Accessory set
3. Expansion group
NOTICE
Fixing of the expansion group can be carried out
on site. See chapter 6.2.
3.2 Storage
The dwelling station "Regudis W-HTU Duo" with
heating circuit separation system must only be stored
under the following conditions:
– Do not store in open air, keep dry and free from
dust.
– Do not expose to aggressive fluids or heat sources.
– Protect from direct sunlight and mechanical
agitation.
– Storage temperature: –20 °C up to +60 °C,
max. relative humidity of air: 95%
3.3 Packaging
Packaging material is to be disposed of environmentally
friendly.
3
2
19