C2Dx 0295-001-000 Manuel page 11

0295-001-072 Rev-1
The Intra-Compartmental Pressure Monitor System (REF 0295-001-000) is intended for use in the electromagnetic environment specified below. The customer or the
user of the Intra-Compartmental Pressure Monitor System (REF 0295-001-000) should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/flicker
emissions
IEC 61000-3-3
The Intra-Compartmental Pressure Monitor System (REF 0295-001-000) is intended for use in the electromagnetic environment specified below. The customer or the
user of the Intra-Compartmental Pressure Monitor System (REF 0295-001-000) should assure that it is used in such an environment.
Immunity test IEC 60601 test level
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
NOTE 1: At 80 MHz and 800 MHz the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures, objects and people.
www.c2dxinc.com
Guidance and manufacturer's declaration - electromagnetic emissions
Compliance
Group 1
Class B
n/a
n/a
Guidance and manufacturer's declaration - electromagnetic immunity
Compliance level
3 Vrms
150 kHz to 80 MHz
3 V/m
80 MHz to 2.5 GHz 80 MHz to 2.5 GHz
Electromagnetic environment - guidance
The Intra-Compartmental Pressure Monitor System (REF 0295-001-000) uses RF energy only
for its internal function. Therefore, its RF emissions are very low and are not likely to cause any
interference in nearby electronic equipment.
The Intra-Compartmental Pressure Monitor System (REF 0295-001-000) is suitable for use in all
establishments, including domestic establishments and those directly connected to the public low-
voltage power supply network that supplies buildings used for domestic purposes.
Portable and mobile RF communications equipment should be used no closer to
any part of the Intra-Compartmental Pressure Monitor System (REF 0295-001-
000), including cables, than the recommended separation distance calculated
from the equation applicable to the frequency of the transmitter.
n/a
n/a
3 V/m
Where P is the maximum output power rating of the transmitter in watts (W)
according to the transmitter manufacturer and d is the recommended separation
Interference may occur in the vicinity of equipment marked with the following
Electromagnetic environment - guidance
Recommended separation distance
,
,
80 MHz to 800 MHz
,
800 MHz to 2.5 GHz
distance in meters (m)
symbol:
(Non-ionizing electromagnetic radiation)
EN
11