Cleaning; Storage; Disposal - Zipper Maschinen ZI-BM870ECO Manuel D'utilisation

Air filter
Clean it every 3 months or after every 30 hours of use, and replace it if necessary.
1. Unscrew the filter box knobs
2. Remove the cover.
3. Remove the filter.
4. Knock it gently on a flat surface.
5. Replace the filter in its housing.
6. Replace the box cover and screw on the knobs.
Fuel tubes
Make sure that there are no cracks in the fuel pipe and that the joints are solid on a daily basis.
Check that there are no fuel leaks. Replace where necessary.
Cutter bar
Clean the cutter bar after every use, particularly the guidance and sliding surfaces. This means
dismounting the cutter. Afterwards, oil all moving parts. Use only biodegradable lubricants!
Refuelling
The machine runs with unleaded petrol/gas.
Ensure yourself that no particles get into the fuel tank when refuelling.
16.2

Cleaning

Clean the machine and the working attachment from soil, dust, grass, chips, and small twigs, etc.
Clean the machine housing with a wet cloth and a mild cleaning solution.
Put on all coatless flats a thin coat of oil.
The usage of solvents, aggressive chemicals or scouring agents damages the
machine housing.
16.3

Storage

If you store the machine for more than 30 days:
Wait until the machine parts are not hot anymore
Cover the machine with a suitable cloth and store it on a dry place
16.4

Disposal

Do not dispose the machine, machine components fuel and oil in residual waste. Contact your
local authorities for information regarding the available disposal options. When you buy at
your local dealer for a replacement unit, the latter is obliged to exchange your old.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BM870ECO
I M P O R T A N T
26