Proposition 65; Installation; Unpack The Machine; Install The Lower Handle - GreenWorks DHA103 Manuel D'utilisation

Amp Rating Total Length of Cord in Feet (meters)
Not
More 25' (7.6
More
Than m)
Than
0 6 18
6 10 18
10 12 16
12 16 14
Keep the extension cord clear of the working area. Position
the cord so that it will not get caught on lumber, tools, or
other obstructions while you are working with a power tool.
Failure to do so can result in serious personal injury.
Check extension cords before each use. If damaged replace
immediately. Never use the product with a damaged cord
since touching the damaged area could cause electrical shock
resulting in serious injury.
2.6

PROPOSITION 65

WARNING
This product contains a chemical known to the state of
California to cause cancer, birth defects or other
reproductive harm. Some dust created by power sanding,
sawing, grinding, drilling, and other construction activities
contains chemicals known to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals
are:
• Lead from lead-based paints;
• Crystalline silica from bricks and cement and other
masonry products;
• Arsenic and chromium from chemically treated lumber.
Your risk of exposure to these chemicals varies depending
on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area,
and work with approved safety equipment, such as dust
masks that are specially designed to filter out microscopic
particles.
Save these instructions.
3

INSTALLATION

WARNING
Before you assemble the machine, read and understand the
safety chapter and the installation instructions.
English
150'
50' (15 100' (30
(45m)
m) m)
16 16 14
16 14 12
16 14 12
Not Recommen-
12
ded
3.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
3.2

INSTALL THE LOWER HANDLE

14
4
22
13
1. Attach the handle holders (13) to the sides of the machine
2. Put the bolts of the handle knobs (22) through the
holders.
3. Turn the handle knobs clockwise to lock the lower handle
(4).
4. Adjust the lower handle in one of the three positions (14).
7
EN
22
13