Rocky Mountain Powerplay Mode D'emploi page 37

34
Walk Mode
The Powerplay has a Walk Mode you can use should the need arise. The Powerplay
TM
Drive is able to assist the bike at a walking speed. On the remote, push and hold button
(A). The bike will slowly power up the climb as you push it.
The Walk Mode may not be used while a rider is on the bike. The Walk Mode may be
used only when walking alongside the bike.
Power OFF
To power down the Powerplay
left idle for 10 minutes, it will automatically shut itself off to conserve battery life.
Notes
Damage to remote
In the event the remote is damaged and stops working, the rider can continue to use
the bike and cycle through the assist modes using the Jumbotron.
NOTE: The menus and adjustments are not accessible via the Jumbotron, without the
remote.
Range
The distance over which the battery will power the drive system varies depending on
several factors, such as assist level and boost mode selected, ambient temperature,
acceleration, wind resistance, poor maintenance, battery age, hilly and rough terrain,
and/or rider weight.
Riding tips
• The Powerplay Drive delivers smooth, natural feeling power to the rear wheel and
TM
works best under these circumstances.
• Use a smooth, consistent pedal stroke, rather than "mashing" the pedals.
• Shift often, to maintain a cadence between 80 and 120 RPM for optimal motor
efficiency, yielding high torque and maximum battery performance. Use the
cadence view on the Jumbotron, which informs the rider when they are pedalling in
the efficient zone.
• When shifting gears, care should be taken:
-Ease off pedalling pressure prior to shifting to avoid stressing the chain.
-Do not shift multiple gears at once.
Drive, hold the button on the Jumbotron. If the bike is
TM
Powerplay Owner's Manual
TM