Rocky Mountain Powerplay Mode D'emploi page 21

18
Powerplay Owner's Manual
Riding the bike
Warning
Make sure the brakes are applied before putting any pressure on the pedals, or even
resting your foot on the pedals. The Powerplay Drive uses a sophisticated torque
TM
sensing circuit to deliver smooth, instant, natural feeling power. This circuit is very
sensitive, so you must be careful to ensure the bike does not accelerate away from you
when stopped.
Power ON
To power up the Powerplay Drive, use the button on the Jumbotron to turn the bike
TM
on, by holding it for 2 seconds. Note: The Powerplay Drive will always power up in
TM
the second lowest assistance mode. The rider can then increase the assistance using
the remote, or the Jumbotron.
Power levels
The Powerplay Drive provides several levels of power assistance:
TM
Level 1: Eco
This is the lowest power setting, used for maximum battery life and rider input.
Level 2: Trail
This level balances assistance and battery life for all around trail riding .
Level 3: Trail+
This level gives the rider sufficient boost for an exciting ride, and good speed to get
you to the downhills, without leaving the battery drained.
Level 4: Ludicrous
For maximum speed and assistance, this level delivers a huge amount of power to the
rear wheel. Note that prolonged use of Ludicrous Mode will drain the battery relatively
quickly.
To change assist levels, use the remote (up or down button) or click the button on the
Jumbotron.
NOTE: THE RIDER CAN CUSTOMIZE BOTH THE POWER SETTINGS OF ALL 4 MODES,
AS WELL AS THE MOTOR BOOST (TORQUE SENSITIVITY) IN THE MAIN MENU.
HOLD TO ACCESS.