Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Warning Labels
For your convenience and safety, the following label is on your laser.
CAUTION: LASER RADIATION - DO NOT STARE INTO BEAM. CLASS 2 LASER PRODUCT.
Laser Information
The DW083 laser level is a class 2 laser product and complies
with 21 CFR 1040.10 and 1040.11 except for deviations
pursuant to laser notice No. 50, dated July 26, 2001.
Introduction
The DW083 laser level is a self-leveling laser tool that can be
used for horizontal (level) and vertical (plumb) alignment. This
tool comes fully assembled. This tool has been designed with
features that allow for quick and easy set-up. Please read and
understand all instructions within this instruction manual prior
to use.
General Safety Rules For Battery
Operated Tools
WARNING! Read and understand
all instructions. Failure to follow all
instructions listed below may result
in electric shock, fire and/or serious
personal injury.
Work Area
•
Keep your work area clean and well lit. Cluttered or dark
areas invite accidents.
•
Do not operate power tools in explosive atmospheres,
such as in the presence of flammable liquids, gases, or
dust. Power tools create sparks which may ignite the dust
or fumes.
•
Keep children and bystanders away while operating a
power tool. Distractions can cause you to lose control.
Electrical Safety
•
Use battery operated tool only with the specifically
designed batteries. Use of any other batteries may create
a risk of fire.
Battery (Fig. A)
This tool is powered by four LR6 (AA-size) batteries.
To install batteries:
1. Lift up the battery compartment cover
Figure A.
2. Insert four fresh AA batteries in the compartment, placing
the batteries according to (+), (-) markings on battery door.
Fig. A
1
WARNING: Batteries can explode, or leak, and can
cause injury or fire. To reduce this risk:
•
Carefully follow all instructions and warnings on the
battery label and package.
•
Always insert batteries correctly with regard to
polarity (+ and –), marked on the battery and
the equipment.
•
Do not short battery terminals.
•
Do not charge batteries.
•
Do not mix old and new batteries. Replace all of them
at the same time with new batteries of the same
brand and type.
•
Remove dead batteries immediately and dispose of
per local codes.
2
1
as shown in
Publicité
