Lionelo Mika Manuel De L'utilisateur page 14

5.
The carrycot in a stroller frame must be installed in a way that the child
is facing the parent who pushes the stroller.
6.
Place the carrycot on the stroller frame with the use of adapters (fig.
10). You will hear a distinctive click. Make sure the carrycot has been
properly attached on the stroller frame.
7.
To detach the carrycot from the stroller frame, press releasing keys on
both sides of the carrycot and then lift the carrycot.
8.
To remove the adapter, press the lower key on the adapter and pull
upwards.
How to install and detach the child safety seat
(applies to the set with Astrid carseat)
Insert adapters (15, fig. b) into corresponding spots on the stroller frame until
you can hear a double click and adapters get blocked (A, fig. 11). Adapters
must be placed with a detachment key in a stroller front direction.
1.
The child safety seat in the stroller frame must be installed in a way that
the child is facing the parent who pushes the stroller.
2.
Place the child safety seat on the stroller frame with the use of adapters
(fig. 11). You will hear a distinctive click. Make sure the child safety seat
has been properly mounted on the stroller frame.
3.
To detach the child safety seat in case it is necessary, remove it from
adapters.
4.
To remove the adapter, press the lower key in the adapter (B, fig. 11)
and pull upwards.
How to adjust safety belts
1.
Insert belts in the central buckle until you can hear a click (fig. 12). To
remove belts, press the key on the central buckle.
2.
To adjust height of the belts, pull them through relevant holes in the seat
so that they correspond to the child's height (fig. 12). You can fasten
belts at three height levels.
How to install and detach safety belts
To detach the belts, pull the buckle through the hole in the seat. To install
them, insert belts again.
EN ‑ 14 ‑