ACM TX PLUS 12D Mode D'emploi page 20

6. Press the MENU key to confirm, Edit blinks:
7. Press the MENU key to change the event settings.
The hour digits blink:
8. Set the time using the UP and DOWN keys and press the
MENU key to confirm. The minute digits blink:
9. Set the minutes using the UP and DOWN keys and press the
MENU key to confirm.
The icon of Channel 1 blinks showing its state ON (active) or
OFF (inactive)
10. Set the channels which must transmit for this event:
using the UP and DOWN keys, select the ON (active) or OFF
(off) state of the channel, press MENU to confirm and proceed
to set the next channel.
11. Repeat this procedure for all 12 channels.
NOTE: This step allows you to associate multiple
channels to the same event by creating groups of
channels that will be activated simultaneously. When
channels are activated they stay on.
12. IAfter setting channel 12, press MENU to confirm.
The opening event icon blinks:
NOTE: If you accidentally have not activated any
channel, programming restarts from step 8
13. Select the desired event using the UP and DOWN keys and
press MENU to confirm and proceed.
14. The icon blinks for 2 seconds to confirm that the operation
was successful, then stays on for 10 seconds.
NOTE: If during the 10 seconds of waiting you press any
key, programming returns to step 4.
15. Programming automatically returns to step 4.
16. Repeat the procedure to schedule all the events of the week.
NOTE: If an event must be repeated over several days,
use the COPY menu to speed up the procedure (see
"COPYING THE EVENTS")
17. Once the programming of all events is over, wait for 30
seconds without pressing any keys.
TX PLUS 12D automatically quits programming and the display
returns to normal view.
NOTE: If you have scheduled events for the current day,
the icon stays on
- 20 -