ACM TX PLUS 12D Mode D'emploi page 13

EU DECLARATION OF CONFORMITY
The manufacturer ACM International srl with headquarters in
Via Oros 2 / g, 00071 Pomezia (Rm) Italy
declares that the products: TX PLUS 12D
comply with the essential requirements established by the
following directives:
2014/53/EU
ROHS2 2011/65/CE
Pomezia, 05/04/2020
The legal representative of ACM International srl
Alfredo Lanzoni
TECHNICAL DATA
Power supply
Frequency
Range in open field
Max.absorption
Dimensions
Weight
DESCRIPTION
TX PLUS 12D is a radio transmitter which controls automatic
shutters and awnings; it allows you to control up to 12 individual
automations or 8 multiple groups.
It can operate in "manual" mode, where you control the
automatisms, or in "automatic" mode, where TX PLUS 12D
controls the automatisms according to the scheduled events.
Events
Possibility to schedule up to 5 events/day.
An event is the occurrence of an automatic control of a
movement (opening or closing of shutters, moving up and down
of awning, etc. ) in a given moment of the day on one or more
days of the week.
For example, an event is the command to open the rolling shutters
at 9:00 AM on Saturday and Sunday while another event is the
rewind of awnings at 7:45 PM on all the days of the week.
Groups
A "group" means a set of automatisms operated at the same
time; for example the awning facing South can be a first group
and all the rolling shutters of the living room the second group.
In automatic mode groups are created during events scheduling
and allows the creation of a different group for each event.
In manual mode the groups must be set according to the
dedicated procedure; in this mode, you can manage up to 8
groups.
SUN function ON/OFF
This function is used to enable or disable the sun sensor and can
be managed in either automatic or manual mode.
2 x Lithium 3V (CR2032 230mAh)
434,15 MHz
150 m
< 25 mA
124x52x21 mm
55 g
OFF
SUN OFF
The intervention of the anemometer on the selected motors /
control units is disabled.
In automatic mode SUN OFF must be associated with an event.
In manual mode, to transmit the SUN OFF command, you must
select the desired channel or the group and press simultaneously
STOP+DOWN for at least 10 seconds, until the motor moves for
about 1/2 second in both directions, indicating the completion of
the procedure.
ON
SUN ON
The intervention of the anemometer on the selected motors /
control units is enabled.
In automatic mode SUN ON must be associated with an event.
In manual mode, to transmit the SUN ON command, you must
select the desired channel or group and press simultaneously
STOP+UP for at least 10 seconds, until the motor moves for about
1/2 second in both directions, indicating the completion of the
procedure.
BATTERY REPLACEMENT
When the battery low indication turns on
proceed as soon as possible to replace the battery; in this situation
there is a significant risk that the controls can not be sent properly.
Open the battery compartment and replace the battery matching
the polarity indicated in the figure.
NOTE: If the device is in ENERGY SAVING mode (display off) and
batteries are replaced in less than 30 seconds, the time and date
settings are retained.
If they get lost, the device turns on automatically starting the
menu "Clock Setting"
WARNING: Batteries contain pollutant elements, must be
disposed of in accordance with environmental regulations (V2
advise to use a specific disposal system).Transmitter contains
pollutant elements too; follow the same procedure to dispose.
Should the batteries lose electrolytic substances, please replace
them immediately avoiding with care any contact with such
substances.
- 13 -
, it is necessary to