ACM TX PLUS 12D Mode D'emploi page 16

4. Press the MENU key, the icon of the day (eg Su) blinks:
5. Set the correct day using the UP and DOWN keys and press
the MENU key to confirm.
The hour digits blink:
6. Set the time using the UP and DOWN keys and press the
MENU key to confirm.
The minute digits blink:
7. Set the minutes using the UP and DOWN keys and press the
MENU key to confirm.
The TIME display blinks for 10 seconds.
If you want to change the time again press MENU and repeat
from step 4 onwards.
If the settings are correct, wait for 10 seconds, the icons TIME
and PROG turn off, the new parameters are stored and the
display returns to normal viewing:
MANUAL OPERATION LOGIC
The manual operation logic of the remote control TX PLUS 12D
allows the direct control of the automation through the use of the
keys.
UP
transmits by radio an opening command
STOP transmits by radio a stop command
DOWN transmits by radio a closing command
SELC
selects the desired radio channel (1 to 12)
SELG
selects the desired channel group (1 to 8)
To control the different automations it is necessary to save TX
PLUS 12D in the different devices.
NOTE: Store the channels with a specific logic to simplify
the management of the automations and the creation of
groups.
To save TX PLUS 12D in the control units, follow the procedure
described in the instruction manual provided with the control
units.
1. The remote must be in MANUAL mode.
If it is in AUTOMATIC mode, press SELC for 10 seconds, the
display shows (example):
2. Select the radio channel by pressing SELC or the group
through the SELG key and send the desired command using
the UP-STOP-DOWN keys
The display shows:
SETTING THE GROUPS
To set the automation groups to be controlled in MANUAL mode,
proceed as follows:
1. The remote must be in MANUAL mode.
If it is in AUTOMATIC mode, press SELC for 10 seconds, the
display shows (example):
- 16 -