Publicité
JET
PUMP
IMPELLER DUCT AND DRIVE SHAFT
5. Install:
• Rear bearing
Bearing inner/outer race
attachment:
YB-34474
NOTE:
• Press the bearing inner/outer race at the
same time holding the drive shaft and impel-
ler duct.
• If a bearing inner/outer race attachment is
not available, use a washer or pipe with an
outer diameter of 46 mm (1.81 in) and an
inner diameter of 20 mm (0.79 in).
6. Add:
• EPNOC grease AP #0 (into the cap)
Quantity:
20 g (0.7 oz)
7. Install:
• Nut
• Impeller
Drive shaft nut:
69 N • m (6.9 kgf • m, 50 ft • lb)
Impeller:
75 N • m (7.5 kgf • m, 54 ft • lb)
LOCTITE 572
Drive shaft holder:
YB-06151
Drive shaft holder 5:
90890-06519
6-19
E
Publicité
Chapitres
