Klarstein Steakhouse Pro Mode D'emploi page 33

1 Place the device in a place where you have enough space for the conversion
and open the door to the maximum angle. Remove the decorative nails (1) with
a small knife (2) and take them out (picture above). Use the Allen screwdriver
(5) to loosen the screws (4) on the fall prevention system (3) and remove the fall
prevention system (lower fi gure).
2 While a second person is holding the door, use the Allen screwdriver (5) to
unscrew the door spindle (6) on both ends of the door. Take the door off and
set it aside.
3 Loosen the screws on the upper suspension (7) and the lower suspension (8)
with the Allen screwdriver (5).
4 Fix the lower suspension (8) on the top left and the upper suspension (7) on the
bottom left of the steak dry ager.
5 Turn the door 180 ° and install the door on the other side of the steak dry ager.
6 Finally, attach the decorative nails (1) and the fall prevention system (3) on the
opposite side.
CAUTION
Risk of injury! To avoid accidents when changing doors, we
recommend that you get help. The glass door is heavy and can cause
injury if it falls.
EN
33