Klarstein Steakhouse Pro Mode D'emploi page 29

Note on built-in devices
• All devices with ventilation slots on the front are suitable for installation, but must not
be installed in completely closed housings.
• Built-in devices suck in air via the ventilation frame and let it out again via the
ventilation frame at the front (some models have the ventilation frame on the back).
• Like many electrical devices, the steak dry ager has many sensitive parts that can
be damaged by a power failure or lightning. Your connections should therefore be
equipped with surge protection.
• If you install the device in a frame with a door, there must be a ventilation opening
in the bottom of the door. In hot climates, slots with a minimum dimension of 40 mm
x 200 mm must also be provided at the top of the rear or at the top on both sides
of the housing so that cool air can flow in. At least 30 mm of space must be left to
the rear wall of the frame. The ventilation slot should not be placed on a side where
another device, such as an oven, is already installed.
Cooling system
Note: This model has a side anti-
thaw tube and an independent
cooling system.
EN
29