Configuration (Dmx); Dmx Personality And Starting Address - Chauvet DJ SWARM 4FX Mode D'emploi

Configuration
(DMX)
DMX Personality
and Starting
Address
Swarm 4 FX User Manual Rev. 2
Set the product in DMX mode to control with a DMX controller. The product uses 3-pin DMX
cable.
Connect the product to a suitable power outlet.
Connect a DMX cable from the DMX output of the DMX controller to the DMX input socket
on the product.
When selecting a DMX starting address, always consider the number of DMX channels used by
the fixture. If you choose a starting address that is too high, you could restrict the access to
some of the product's channels.
The Swarm 4 FX uses up to 12 DMX channels in the 12-channel mode, 12CH, which means the
highest recommended DMX address for that personality is 501.
The Swarm 4 FX uses 2 DMX channels in the 2-channel mode, 02CH, which means the highest
recommended DMX address for that personality is 511.
If you are not familiar with the DMX protocol, download the DMX Primer from
http://www.chauvetlighting.com/downloads/DMX_Primer_Rev6_WO.pdf.
To select the DMX personality and starting address, do the following:
Press <MENU> repeatedly until d001–d511 shows on the display.
Press <ENTER> and 02CH or 12CH will show in the display
Use <UP> or <DOWN> to select the DMX personality.
Press <ENTER> and d001–d511 (for 02CH) or d001–d502 (for 12CH) will show on the
display.
Use <UP> or <DOWN> to select the DMX personality.
Press <ENTER>.
The display will continue to blink until the fixture receives a DMX signal.
Page 19 of 80