Timer Operation - Toshiba RBC-SR1-PE Mode D'emploi

All manuals and user guides at all-guides.com
AI R
EMOTE
T
IMER
The Main Isolation Switch needs to be set to the "on" position (the operation lamp flashes).
During timer operation, the remaining time is displayed. This is updated every minute.
The timer operation range is from 10 minutes to 60 hours in 10 minute steps.
1. TIMER Button
This button selects the timer mode OFF, ON or CONTINUOUS.
Set the timer in the OFF or the ON mode.
2. TIMER ADJUST ( ) Buttons
The ON or OFF times can be set by these buttons.
MODE FAN CENTRAL
FAN ONLY AUTO OPERATION
COOL HIGH STANDBY
MED PREHEAT
HEAT LOW DEFROST
AUTO FILTER
TEMP CHECK LOUVER
UNIT MANUAL
˚ C
88
TIMER CONT. OFF ON ADDRESS
88 : 88
H M
When the timer adjust button is pressed once, the time changes by 10 minutes. If the button is
held, the time changes in 1 hour steps.
If the operation LED is illuminated, the timer operation will start on completion of the setting.
If the operation LED is not illuminated, the timer operation will start on the operation of the ON/OFF
button.
The remaining time can be seen throughout the timer operation.
ON Timer The air conditioner starts
(STOP 'START) operation when the time is up
OFF Timer The air conditioner stops
(START 'STOP) operation when the time is up
To Stop the timer Operation
Push the ON/OFF button.
The LED goes off and the air conditioner
stops even if the set time is not reached.
The set on or off time will be saved.
To Clear the timer
Push the timer button
When the timer is pressed, the timer
operation is suspended.
GB
C
ONTROLLER
O
PERATION
NETWORK
REMOTE CONTROLLER
MODE
- +
TIMER ADJUST
CHECK FILTER
2
ON/OFF
1
Operation Start
Stop
Remaining Time
7.00pm
On
RUN Lamp
Operation Start
Stop
Remaining Time
7.00pm
On
RUN Lamp
To Change the Set Time
Follow steps 1 & 2 above. Pressing ON/OFF will
then adjust the timer.
The operation LED illuminates and the newly
set timer operation starts.
– 8 –
Off