THOMSON TIH470FLEXI Notice D'utilisation page 36

• The piece of furniture or the support in which the hob has to be fitted, as well as the
edges of furniture, the laminate coatings and the glue used to fix them, must be able to
resist temperatures of up to 100 °C.
• The mural rods of edge must be heat-resisting.
• Do not install the hob to the top of a non ventilated oven or a dishwasher.
• If a drawer is below the hob, to guarantee a good air circulation and good cooling system
of the appliance, maintain a gap of 20 mm minimum between the bottom of the drawer
and the inferior part of the hob.
• WARNING: The safety gap between the hob and the cooker hood placed above must
respect the indications of the hood manufacturer. In case of absence of instructions
respect a distance minimum of 760 mm.
• If a drawer is placed under the work, avoid to put into this drawer flammable objects
(for example: sprays) or not heat-resistant objects.
• The connection cord should be subjected, after built-in step, to no mechanical constraint,
such for example of the fact of the drawer. Materials which are often used to make
worktops can expand on contact with water. To protect the cut out edge, apply a coat of
varnish or special sealant.
• WARNING: Use only hob guards designed by the manufacturer of the cooking appliance
or indicated by the manufacturer of the appliance in the instructions for use as suitable or
hob guards incorporated in the appliance. The use of inappropriate guards can cause
accidents.
35