Beta 560C3 Mode D'emploi page 5

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
ANTI - WIND UP SYSTEM
1. Set the 'direction selector of the anti-wind up system' to the proper operating direction:
- clockwise operation / bolt tightening
- counterclockwise operation / bolt release
Tightening
Test the direction of rotation and make sure that the system operates freely.
DO NOT USE THE TOOL IF THE DEVICE DOES NOT OPERATE FREELY.
2. To apply the torque, follow the instructions for setting and using the torque multiplier above.
Set the direction of operation for the anti-wind up system.
3. To remove the torque multiplier, accurately load the gear cover until the 'direction selector of the
anti-wind up system' can be moved into the neutral position. Allow the torque wrench to rotate slowly,
until the torque multiplier can run freely.
4. The tool can be removed from the fastening device.
5. Get used to this item by initially applying low torques and the anti-wind up system.
NB: The gears and teeth of the anti-wind up system should be checked for wear or damage every year.
IMPORTANT NOTICE:
These tools are meant for professional use; therefore, they must be used by trained personnel only. Any
other use shall be deemed to be improper. Always use personal protection devices and comply with
safety standards in the workplace.
Release
EN I
5