Remington CI67E1 Mode D'emploi page 4

ENGLISH ENGLISH
• Do not set the appliance down while still on.
• Do not twist or kink the cable, or wrap it round the appliance.
• Do not use the appliance if it is damaged or malfunctions.
• Do not wrap the cord around the unit. Check the cord regularly for any sign damage.
• This appliance is not intended for commercial or salon use.
• Let the appliance cool down before cleaning and storing away.
PARTS
1. 25 / 38 mm barrel
2. Tong clip
3. Digital display
4. + Temperature control
ADJUSTING THE BARREL
The barrel can be adjusted to 25 mm or 38 mm. To adjust, twist the cool tip to decrease (fig.
A) or increase (fig. B) as required. The 25 mm setting creates tight curls, the 38 mm setting
creates looser curls. When first heating, set the barrel to 25 mm for best results.
INSTRUCTIONS FOR USE
• Before use, ensure the hair is clean, dry and tangle-free.
• For extra protection use a heat protection spray.
• Hairsprays contain flammable material - do not use while using this product.
• Section the hair prior to styling. Style the lower layers first.
1. When the styler is plugged in but not turned on a lock symbol will show in the display
window indicating the styler is in standby mode L .
2. Press the on/off button to switch on.
3. Select the desired temperature.
4. To adjust the temperature use the +/- temperature controls on the side of the product.
'+' increases the temperature '-' decreases the temperature.
Temperature
150°C - 160°C
160°C - 180°C
180°C - 200°C
5. The selected temperature will flash continuously until the desired temperature is
reached.
Note: For the best results, set the barrel size to 25mm and allow to heat for 2 minutes at
the selected temperature. Adjust the barrel size as required before styling.
4
5. – Temperature control
6. On/off button C
7. Cool tip
8. Swivel cord
Hair type
Thin/fine, damaged or bleached hair
Normal, healthy hair
Thick, very curly and difficult to style hair