Cleaning And Care; Thermal Protection Device - Dualit NewGen D2VHMA Mode D'emploi

CLEANING & CARE
IMPORTANT: ensure the toaster is isolated
and allowed to fully cool before starting to clean.
Any other servicing should be performed by authorized service representative.
THE COVER
1
AFTER EACH USE
Wipe the 'stainless steel cover' with a non-abrasive cloth.
A stainless steel cleaner can be used to restore shine to
the cover only, but do not use an aggressive cleaner or
one that contains ammonia.
3
THE CRUMB TRAY
Crumbs will accumulate in the With the toaster isolated from the power supply use a
crumb tray and could catch fire if SOFT BRUSH to clean inside your toaster, do not
the tray is not emptied frequently. use a sharp or metal utensil! Crumbs should be carefully
Pull out the crumb tray and wipe brushed off the elements using only a soft brush, the
clean using a damp cloth. CRUMB toaster can be turned upside down and excess crumbs
TRAY MUST BE IN PLACE
be shaken out.
DURING TOASTING.
THE CASTINGS
2
Wipe the aluminium end castings
with a damp cloth. Do not use a
chemical or abrasive cleaner.
4
THE INTERNALS
16

THERMAL PROTECTION DEVICE

TO PREVENT
1
ACTIVATING THE
THERMAL
PROTECTION
DEVICE:
• Ensure your toaster is
situated in an area with at
least 20cm of space to the
left, right and back of the
toaster.
• Use the toaster clear of Always load bread into the
overhanging cupboards and
toaster starting from the left
away from any flammable hand slot.
materials.
3 4
FURTHER ROUNDS WARMING RACK
st
1
nd
2
rd
3
Be mindful of reducing the Be mindful that repeated use
toasting time if the toaster is of the Warming Rack
already warm from previous without allowing the toaster
use, as the bread toasts faster to fully cool between cycles
on 2nd and 3rd cycles. may cause the device
to activate.
2
Always use the
appropriate setting
for the number of
slices of bread to be
toasted.
5 UNPLUG
Always isolate the toaster
after use.
17