ERKA. ERKAMETER 125 PRO Manuel De L'utilisateur page 13

First insert the free end of the cuff air tube into the connection
provided on the device.
Open the cuff to form a ring and fit this over the bare left upper
arm, above the elbow. Make sure that the arm is not affected by the
hitching up of the sleeve in the event of tight-fitting clothing.
The cuff must be positioned about 2 finger widths above the elbow
with the tube pointing in the direction of the wrist. The cuff itself must
not be twisted at all.
The arrow printed on the cuff must be positioned over the brachial
artery.
Close the cuff so that it is close-fitting but not constricting.
Tighten the end of the cuff fed through the cuff bracket and press it
against the Velcro.
for 30 seconds. As a result, take the time to calmly position the blood
pressure cuff on the arm and then confirm that it has been positioned
correctly. Then switch on your device and start the blood pressure
measurement.
ERKA_Manual_ERKA125_PRO_11_2020.indd 13 ERKA_Manual_ERKA125_PRO_11_2020.indd 13
2 - 3 cm
PLEASE NOTE: The Erkameter 125 PRO has an automatic
switch-off function that is triggered if the device is not used
Marking
Artery
13
26.11.2020 10:56:50 26.11.2020 10:56:50