Start-Up; Charging The Battery; Switching Your Device On And Off - ERKA. ERKAMETER 125 PRO Manuel De L'utilisateur

1.3

START-UP

1.3.1 CHARGING THE BATTERY

Please fully charge your device's battery before initial use. The Erkameter
125 PRO has a permanently installed lithium polymer battery with no
memory effect. You can charge the battery at any time without having to
consider discharge times. A full charge is performed in two steps and takes
up to four hours.
The mains connector has to be fitted with the relevant plug adapter for
the specific country.
Then connect the USB connection to the device using the enclosed
USB cable. The other end of the USB cable then has to be connected
to the mains connector before this is inserted in the socket.
charge the battery at any time without having to consider discharge times.
A fully charged battery is sufficient for seven days of recording.
The battery may only be charged at an ambient temperature of 10-45°C.
Do not charge the battery in direct sunlight or on a heater.
1.3.2
To switch the device on, hold down the ERKA.
3 seconds. The device switches off automatically after about 30 seconds
if no other buttons are pushed. It can also be switched off in the start
screen by pressing the OFF icon.
ERKA_Manual_ERKA125_PRO_11_2020.indd 11 ERKA_Manual_ERKA125_PRO_11_2020.indd 11
INFORMATION ABOUT RECHARGEABLE
able battery is a lithium-ion battery with no memory effect. You can

SWITCHING YOUR DEVICE ON AND OFF

BATTERY.
-Button for about
11
The recharge-
26.11.2020 10:56:50 26.11.2020 10:56:50