Installing The Side Legs - Roca EMOTION Manuel D'installation Et D'utilisation

done by means of a connection system with a protection level
of at least IPX5 and it must be located at more than 20 mm from
the floor.
- The power cable must be connected to 230 V/50 Hz 60 Hz and
earthed.
- The bathtub electrical installation must be protected by a 30
mA differential breaker and a 3 A magnetothermal breaker with
omnipolar disconnection devices and a distance between con-
tacts of at least 3 mm. Both switches must be placed outside the
volumes in the bathroom.

9- INSTALLING THE SIDE LEGS

Each set of side legs is made up of the following:
- A cleat (with suction pads).
- A right leg (with silicone seal).
- A left leg (with silicone seal).
N.B.: Before joining the parts, place them on the bathtub to
make sure they will be installed correctly.
1
- Starting at the rear of the cleat and using an Allen key, attach
the legs using the cylindrical M6x20 Allen screws. See Fig. 7. Do
not tighten them all the way in order to leave a margin for adjust-
ment in the next operation.
Fig. 7
2
- Clean the surface of the suction pads that will be touching the
floor; and the surface of the floor, to ensure good adherence.
Once the two legs have been attached, place them facing the
tabs that stick out from the bathtub. Fig. 8.
If the floor is uneven and correct adherence is not achieved, you
have the following options:
A- Place sheets of metal under the suction pads, using silicone to
attach them to the floor.
B- Install the attachments included in the bag of nuts and screws
as follows:
B1. Place the set of legs against the bathtub and mark
the position where the drill holes will be made in the floor, accord-
ing to the measurements in the attached diagram.
See Z
��
Floor attachment
B2. Drilling. Place the plug and the wing-nut shaped
attachment included in the bag, passing the self-tapping screw
through the hole. See Y.
Note: Place the wing nuts parallel to the cleats.
B3. Place the set of legs against the bathtub again and,
after inserting the tabs that stick out from the bathtub, turn the
wing nuts using a no. 10 spanner.
3
. Insert the M6 studs from the bottom and attach them using an
Allen key. Fig. 9.
Fig. 8
Fig. 9
13
Z:
Mark at the middle
point of the cleat
Attachment point