Philips Elance GC3135 Mode D'emploi page 6

ENGLISH
6
For Auto-shut-off versions (type GC3135 only)
If the Auto-shut-off is activated (red pilot light blinks), move the iron
slightly to deactivate it (blinking stops).
Steam-ironing
Make sure that there is enough water in the water tank.
1 Set the temperature control to the recommended position.
See section 'Setting the temperature'.
C
2 Set the steam control to the appropriate steam position.
- 1 - 2 for moderate steam (temperature settings 2 to 3)
- 3 - 4 for maximum steam (temperature settings 3 to MAX)
Steaming will start as soon as the set temperature has been reached.
B
If the selected ironing temperature is too low, water may drip
from the soleplate. Types GC3135, GC3130, GC3126, GC3125,
GC3120, GC3115 are equipped with a drip stop system (refer to
'Drip stop' further on).
Ironing without steam
1 Set the steam control to position O (= no steam).
2 Set the temperature control to the recommended position.
See section 'Setting the temperature'.
Other features
Spraying
To remove stubborn creases at any temperature.
Make sure that there is enough water in the water tank.
C
1 Press the spray button a couple of times to moisten the
laundry.
Shot of Steam
A powerful "shot" of steam helps remove stubborn creases.
The Shot-of-Steam function can only be used at temperature settings
between 2 and MAX.