Code Learning - Marmitek EASYTOUCH 35 Mode D'emploi

easytouch35_manual ok

13 Code Learning:

It is possible to learn IR commands (up to 40 keys per Mode) from your original remote.
Tips On Learning:
1. Always use of fresh batteries for the ET35 and original remote
2. Carry out a Master Clear before attempting any Learning.
3. Place the original remote to the base of the Touchscreen so the IR LED on the original
remote is in line with the Touchscreen opto-diode input (See graphic below).
4. Keep the distance between the two remotes to about 5 cm.
5. Experiment by Learning 2 or 3 keys initially and then carry out a Master Clear before
completely Learning your original remote's keyboard.
6. Do not attempt to Learn directly under an incandescent or low-energy light.
7. When Learning a key, do not release the key being Learned until the display returns
and the LED remains on. This can take 2-3 seconds.
8. No functions may be stored under the Touchscreen SCREEN, LIGHT, SLEEP, P<P,
SEARCH keys or under rubber keys Setup, Macro, TV, VCR, DVD, CBL, SAT, CD,
Marmitek X-10 Home Automation or Audio keys. It is not possible to learn under
"shifted keys".
To Learn Commands:
1. Press and hold Setup key until the LED remains on
(occurring after approximately 2-3 seconds) and the
display shows the Main Setup Screen.
2. Release Setup key.
3. Press and release Touchscreen "LEARN" Key.
18
6/17/03 10:30 AM Page 18
MARMITEK