Marmitek EASYTOUCH 35 Mode D'emploi page 10

easytouch35_manual ok
6. Display will show the Code Setup Screen. Using the Table
blow, press and release the numeric key (0-6)
corresponding to desired Manufacturer. Note – pressing
"0" carries out a full library search same as normal Code
Search Method.
Digit
Key
Press
1
2
3
4
5
6
7. Press and release the Touchscreen "SEARCH" Key.
8. Display will show the Search Setup Screen. Press the
Touchscreen "UP" key (or Power or Play) repeatedly until
the Device to be controlled changes channel.
Alternatively, you can use the Channel Up & Down keys.
Press and release the Touchscreen "OK" (or Mute) key to
install the Code. Display will return to the Main Setup
Screen.
If you accidentally overshoot the Code required, press the
Touchscreen "DOWN" or Channel Down to backtrack
through the Library to return to the correct code. Pressing
the Touchscreen "UP" key (or Power or Play) will change
direction to forward again.
9. Repeat this procedure for any other appliance you want
to control (TV, VCR, DVD, SAT, CD, CBL, AUDIO and
Marmitek X-10 Home Automation).
10. The Code Search Method entry is now complete. Press
and release the Touchscreen "EXIT" key to return to normal operation.
Notes:
a. When all codes under a Brand have been searched the LED will "error" flash
indicating end of search and Main Setup Screen will be displayed.
b. The above search procedure assumes that you want to store VCR codes under the
VCR key, Cable codes under CBL, etc. If you want, for example, to store a VCR code
10
6/17/03 10:30 AM
Brand
PHILIPS
SONY
THOMSON
SABA
GRUNDIG
NOKIA
Page 10
MARMITEK