Inventum AKD8005ZWA Manuel D'utilisation page 33

Caution:
Make sure that the appliance is off and that the mains plug is removed from the mains socket.
Caution:
Do not use abrasive cleaning agents or cleaning agents that contain alcohol.
CLEANING THE APPLIANCE
1. Clean the inside and the outside of the appliance. Use hot water and a mild cleaning agent.
2. Clean the control panel of the appliance. Use a damp cloth.
CLEANING THE GREASE FILTER
1. Open the cover of the appliance.
2. Push the latch (A).
3. Support the grease filter (B) and remove it from the appliance.
4. Clean the grease filter. Use hot water and a mild cleaning agent.
5. If necessary, clean the grease filter in a dishwasher. Use a program with a low temperature.
Note:
The grease filter can change color after cleaning. This is normal.
6. Make sure that the grease filter is dry before installing.
REPLACING THE CARBON FILTER (OPTIONAL)
Note:
The carbon filter must be replaced every 4 months.
Note:
This procedure is only valid if you installed the carbon filter with your appliance.
1. Open the cover of the appliance.
2. Remove the grease filter.
3. Replace the carbon filter (A).
4. Install the grease filter.
REPLACING THE LAMP
Preliminary requirements
• Lamp 3 W LED GU10 (2x)
Procedure
1. Remove the grease filter.
2. Push the lamp holder (B) down from the inside.
3. Carefully turn the defective lamp (A) clockwise out of the holder.
4. Replace the lamp with a new one.
5. Turn the new lamp counterclockwise into the holder.
(Figure 12)
(Figure 13)
(Figure 14)
English • 33