Installation Example - Videotec DCIR Manuel D'instructions

Connecting: DCIR – Receivers (MICRODEC485, DTRXDC, DTRX3, DTMRX1)
See the table below (Table 2) for connecting the DCIR with the receiver. See Table 1 above for the other
connections with the matrix (which powers the DCIR).
DCIR
(RJ-Jack)
TX-485A Black
TX-485B Blue
Table 2
If the DCIR remote control is only used for telemetry (with no matrix connected) it will need a
power supply (12 V =) using the RJ jack shunt box in the two terminals shown as +12V= and GND in
the table 1. It will also be necessary to set dip2 of SW1 to ON position (in this case it is possible to
control up to a maximum of 16 receivers).

Installation example

Installation controlled by one operator with two monitors: the operator controls the video switching, the
alarm contacts handling, a group of receivers for the movement of the pan & tilt motors and zoom lenses.
VIDEO MAT RIX
MICRODEC485, DTRXDC,
DTRX3 DTMRX1
---- RX-485A
---- RX-485B
DCIR
RPRC36
POWER SUPPLY 12 VDC
MATERIAL USED
Control keyboard:
• 1 remote control unit DCIR
Video:
• 1 SM82A matrix
• 2 monitors
• 2 cameras
Telemetry:
•
• 2 pan & tilt motors
Pag. 8
Max 1000 m
RS 485
2 receivers DTMRX1
DTMRX1
DCIR_4402