Safety Rules; Identification Data; Description Of The Remote Control Dcir - Videotec DCIR Manuel D'instructions

Safety rules

The remote control DCIR complies with the normative laws in force at the time of editing of this manual,
concerning electric safety, electromagnetic compatibility and general requirements.
Anyway, in order to ensure the users (installer technician and operator), the following warnings are specified for
safety's sake:
• Connect to a feeder corresponding to the specifications indicated on the data plate (see next chapter

Identification data)

• The appliance (and the complete system, which it belongs to) must be installed only by a qualified technician
• For after-sale service call only authorized technical staff.
• The tampering of the appliance may void the guarantee terms.
• Before any shifting or technical operations on the appliance, unplug it from the mains: the appliance is
completely off-line only when the plug is disconnected and the cables connected to other appliances have
been removed
• Do not use extensions showing wear or aging, since they may seriously compromise the users' safety
• Avoid wetting the appliance or touching it with wet hands, while it is in operation
• Do not leave the appliance exposed to atmospheric agents
• Do not use the appliance in the presence of inflammable substances
• Do not allow children or people not familiar with the appliance to use it
• Make sure the appliance always rests on a solid and large enough base
Keep this manual close to hand for any future reference.
Identification data
On the rear side of the DCIR remote control there are two plates complying with EC specifications.
The first plate shows model identification code (Bar code EXT3/9).
The second plate shows the model serial number (Bar code EXT3/9).
On the external power supply a plate shows the electrical specifications.
When installing the appliance, check that the power supply specifications of the remote control correspond to
those required. The use of improper appliances may seriously compromise the safety of the personnel and the
installation.

Description of the remote control DCIR

The DCIR remote control is a professional product for applications within the sphere of safety and
surveillance. In a safety system, it allows the video switching control (via SM42A / SM82A / SM84A / SM164A /
LXRPS42A / LXRPS82A / LXRPS42TA / LXRPS82TA / LXRPS84A / LXRPS164A video matrix) and the
peripheral stations control (via DTMRX1, DTRX3 receivers).
Features:
• Two RS485 communication lines (video line and telemetry line)
• Choice of video line protocol, between MACRO (for the new SM series matrixes with telemetry via coaxial
cable) and Linxs (LXRPS series matrixes)
• Choice of telemetry line protocol, between MACRO and standard Videotec
• Choice of communication rates (38400, 19200, 9600 or 1200 baud), on both video and telemetry lines
Pag. 3 DCIR_4402