Lionelo Riya Manuel De L'utilisateur page 11

Do not put an additional mattress into the carrycot.
11.
Stroller parts list (fig. A, B)
1.
Sunshade
2.
Handle
2a. Handle adjustment key
3.
Bow release key
4.
5-point harness
5.
Footrest adjustment key
6.
Front wheel release key
7.
Front wheels
2in1 set includes stroller frame with seat and carrycot.
Carrycot parts list (fig. C, D, E) – applies to 2in1 set
15. Sunshade
16. Carrycot connector with key
17. Carrycot supports
18. Mattress
How to assemble and disassemble stroller
1.
Stroller frame unfolding: open the unfolding lock (10) and then pull the
handle up until you can hear a click (fig. 2).
2.
Place the seat on the stroller frame (fig. 1a). Unfold and secure the seat with
a bow until you can hear a click. Correct assembly of the seat on the frame
is signaled by the click. Make sure the seat has been properly mounted in
the stroller frame.
3.
To remove the seat from the stroller frame, press the release key on both
sides of the seat and then lift them (fig. 1b).
4.
To assemble the seat in a rear-facing position (fig. 1c), press the release key
and then lift the seat and place it in a desired position. The seat is properly
mounted when you can hear a distinctive click.
5.
To remove the sunshade, unzip it and then pull up plastic elements on both
sides (fig. 1d).
6.
To remove seat covering, unzip it around footrest and under the seat, and
unzip belts at the base of the seat.
8.
Basket
9.
Backrest adjustment lever
10. Folding lock
11. Locking mechanism
12. Rear wheel release key
13. Rear wheels
14. Swivel wheel lock key
‑ 11 ‑ EN