INE SKYLINE HFP3000 Manuel D'instructions page 32

INE SpA Via Facca, 10 - 35013 Cittadella - PADOVA - ITALIA Tel. 049/9481111 - Fax 049/9400249 - ine@ine.it - www.ine.it
13.3 Program management
In total, 99 welding programs can be saved. To access
program management:
•
Press and hold down 'E2' for a few seconds, or on
the screen icon ; the display changes as shown
below.
E1
•
Turn one of the rotary switches and tap the program
management icon
Alternatively, tap the icon on the screen.
The display changes as shown in the following diagram.
For ease of use, we recommend using the touch screen
for subsequent operations
E1
Saving a program:
This procedure saves the current machine settings.
•
Turn one of the rotary switches and select the
memory cell to be used. Alternatively, tap the icon on
the screen.
•
Press either one of the rotary switches twice.
Alternatively, tap the icon on the screen. The
program is saved.
E1
If is tapped to save the program
appear that allows you to input a specific description.
E2
; to confirm, press 'E2'.
E2
E2
, a keyboard will
Loading a program:
This procedure recalls the settings of a selected
program.
•
Turn one of the rotary switches and select the
memory cell to be used. Alternatively, tap the icon on
the screen.
•
Press either one of the rotary switches once. Turn
the rotary switch to highlight icon
once more. Alternatively, tap the icon on the screen.
The program is recalled.
Deleting a program:
This procedure deletes a previously saved program.
•
Turn one of the rotary switches and select the
memory cell to be deleted. Alternatively, tap the icon
on the screen.
•
Press either one of the rotary switches once. Turn
the rotary switch to highlight icon
once more. Alternatively, tap the icon on the screen.
After confirmation the program is deleted.
Rapid recall of stored programs
After storing at least 1 program, on the main screen in
the bottom right corner (see figure below), the first 3
programs can quickly be recalled saved in numerical
order by tapping the relative icon.
E1
Page 30
and press it
and press it
E2