Die Loading/Changeover - Greenlee Shear 30T Manuel D'instructions

Die Loading/Changeover

If a die set is already loaded in the cutting unit, pull the
Swing Arm out of the Mobile Die and rotate it onto the
Die Spacer. Pull back the End Stop and slide out the
Mobile Die within the Cassette Frame, then push the
Stationary Die forward and slide it out also. Load the
new die set in a reverse matter. Be sure to reengage the
Swing Arm before beginning cutting.
Note: if having difficulty removing or inserting dies, clear
debris from the Cassette Frame die pockets.
Note: it is recommended to apply a moly-base
spray lubricant to the die and frame working surfaces
whenever changing dies.
6
Greenlee Tools, Inc.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070