Caster Mounting - Greenlee Shear 30T Manuel D'instructions

Caster Mounting

Rotate the Service Cart on its side.
Cart is heavy, advise having two persons when
turning cart.
Attach the Rigid and Swivel Casters to the bottom
shelf of the Service Cart with the included caster
mounting hardware. Torque the nuts to 25 ft lbs.
Reposition the Service Cart with casters in its
upright position.
Transporting and Storage
Remove all dies from the Cutting Unit. Lower the Rear
Rod Rest and Measurement Stop. Center both Extension
Arms; lock the arms by tightening the Rear Arm Knob
and Measurement Stop Knob.
Connecting to Power Source
Attach your 10,000 psi rated pump to the Hydraulic
Ram's universal coupler with a similarly rated hydraulic
hose. The Service Cart has an opening in its upper
shelf for the hose to feed through if the pump is seated
on the lower shelf. Tighten the hydraulic fitting and
test cycle the Cutting Unit unloaded to confirm a
proper connection.
Greenlee Tools, Inc.
5
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070