Redmond RI-C220-E Mode D'emploi page 7

5. Press and hold down the "Self­clean" button until hot water and steam are no
longer released from the soleplate. Swing the iron lightly back and forth. Steam
and hot water releasing from the soleplate will remove scale and other debris.
6. Open the cap and empty the water tank. Close the cap.
7. The soleplate can be wiped with damp cloth when cooled.
8. Repeat the self­cleaning procedure if necessary.
To clean soleplate
1. Before cleaning the soleplate ensure that the iron is unplugged and cooled
down thoroughly.
2. Cool soleplate can be wiped with damp cloth or sponge. Use ceramic soleplate
cleaner if necessary.
DO NOT immerse housing, power cord, or power plug in water.
DO NOT use sponge with hard or abrasive surface or abrasive and solvent-based
cleaners (gasoline, acetone, etc.).
Iron storage
The appliance must be stored in a dry location away from direct sunlight or heating
appliances. Store the iron in the vertical position to avoid damage to the soleplate.
To keep the soleplate in good condition do not allow it to come into contact with
metal and other hard or sharp objects.
IV. BEFORE CONTACTING SERVICE
CENTRE
Problem Possible cause
Power cord is not connected to
an electrical outlet
Soleplate remains Electrical outlet is not function­
cold, heating indicator ing properly
does not light up
Auto shut­off feature activated
(auto shut­off indicator on the
handle is flashing)
Soleplate barely
Selected temperature is too low
warms up
Problem
Iron produces no
steam
Iron produces very
little steam
Brown streaks come
from the holes in
soleplate and stain
fabric
Soleplate is dirty and
stains the fabric
Solution
Water drips from the
Connect to an electrical outlet.
holes in the soleplate
Connect to properly functioning
electrical outlet
V. PRODUCT WARRANTY
Refer to section "Auto shut­off
We warrant this product to be free from defects for a period of 2 years from the date
feature"
of purchase. If the appliance fails to operate properly within the warranty period and
is found to be defective in material or workmanship, we will repair or replace it free
Turn the temperature control
of charge. This warranty comes into force only in case an original warranty service
dial to select the required tem­
coupon with a serial article number and an accurate impress of the company of the
perature
RI-C220-E
Possible cause Solution
The steam output control dial is
Turn steam output control dial
set to minimum setting, steam
to select required steam output
feature is disabled
The water tank is empty Fill the water tank at least ¼ full
The steam output control dial is Turn the steam output control
set to medium setting dial to increase the steam output
You used water with chemical Do not use water with chemical
additives additives
You used distilled or softened Use common tap water or half
water tap water and half distilled water
Carry out the self­cleaning
You did not empty the water
procedure. Always empty water
tank after last use
tank after use
Clean the soleplate. Refer to
Selected temperature is too
Fabric Ironing Chart to select
high
the correct temperature
Clean the soleplate. Thoroughly
Fabric has not been rinsed suf­
rinse the garment to remove any
ficiently or you have ironed new
traces of detergent residue that
garment before washing it
may damage the soleplate
Turn the temperature control
Selected temperature is too low dial to select ••, ••• , or max
position
Te soleplate temperature is too
Increase the intervals between
low because you are using the
the steam shots
Steam Shot feature too often
GBR
7