10.2.2. Deleting the command timer
Delete the set timer here ("Bell symbol in the display").
Carry out steps 1 to 5 as instructed above. The dis-
play will read TIMER1 CLEAR.
Press O K . CONFIRM CLEAR is displayed.
Press O K . The confirmation message appears:
SUCCESS.
11. Learn function
You can manually save the functions of an original re-
mote control to your universal remote control. The
universal remote control can "learn" up to 150 com-
mands.
11.1. Notes on the learn function
•
Use new batteries for both remote controls.
•
First delete all default commands if you are starting
the programming from the beginning (especially
after the device has been used for the rst time).
•
Only one original remote control can be pro-
grammed on each source key.
•
If you would like to program an original remote
control to a source key, first delete the commands
on this source key.
If the memory is full, ERROR appears. If this hap-
•
pens, delete the commands stored in the memory.
•
Programming each button takes approx. 3 sec-
onds. In each case, do not release the button until
DE
FR
EN
NL
39