Keurig B50 Mode D'emploi page 8

Stopping the Brew Process
If you need to stop the brewing after the
process has started, press the Power Button
and turn the Brewer 'OFF'. The flow of coffee
or tea will stop and the heating element will
shut off and the green light illuminating the
Power Button will disappear.
NOTE: You may get less coffee or tea in
your cup during your next brew. We
recommend that you perform a cleansing
brew with water only after a terminated brew.
Then your NEXT brew will be the volume
you have selected.
8
Adding Water
The LCD Message Center of your Brewer will
indicate when the water level in the tank is low
or if the Water Reservoir has been removed by
displaying the words 'ADD WATER'. The
Brewer will not allow you to brew when 'ADD
WATER' is flashing.
ADD WATER
The Water Reservoir can be filled in two ways.
1. Lift off the Water Reservoir Lid and pour
water directly into the Water Reservoir
while it is still attached to the Brewer, then
replace the Lid.
2. Remove the Water Reservoir by lifting it up
and away from the Brewer, lift off the Water
Reservoir Lid and fill with water. Replace
Lid and place the Water Reservoir back in
its base.
IMPORTANT: Do not remove the Water
Reservoir during the brewing process.