Start-Up And Use; Practical Advice On Using The Burners - SCHOLTES PPF 20DC 120 Mode D'emploi

Start-up and use

! The position of the corresponding gas burner or electric
hotplate is shown on every knob.
Gas burners
Each burner can be adjusted to one of the following
settings using the corresponding control knob:
0
0 Off
Maximum
Minimum
To light one of the burners, hold a lit match or lighter
near the burner and, at the same time, press down and
turn the corresponding knob anti-clockwise to the
maximum setting.
Since the burner is fitted with a safety device, the knob
should be pressed for approximately 2-3 seconds to
allow the automatic device keeping the flame alight to
heat up.
When using models with an ignition button, light the
desired burner pressing down the corresponding knob
as far as possible and turning it anticlockwise towards
the maximum setting.
! Some models have a Double Flame burner. In this
case, to activate it, simply start by turning the knob
so that it is aligned with the
it all the way in and hold it in this position for
approximately 6 seconds, until the automatic device
keeping the flame alight has heated up.
! If a flame is accidentally extinguished, turn off the
control knob and wait for at least 1 minute before trying
to relight it.
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the ""/"
The "separate double flame" burner*
This burner consists of two concentric burners which
can operate either together or separately.
Use of the double flame on the maximum setting gives
a very high power which reduces cooking times with
respect to conventional burners.
Moreover the double flame crown provides a more
uniform distribution of heat on the bottom of the pan,
when using both burners on minimum.
To ensure that the double-flame burner is used to its
full potential, never set the inside ring to minimum and
the outside ring to maximum at the same time.
Pots and pans of all sizes can be used. In the case of
the smaller pots and pans we recommend the use of
only the internal burner.
There is a separate control knob for each of the
"separate double flame" burners.
The knob marked by the symbol
external burner;
(models PPF...BNV...) (models PPF...BNV...)
(models PPF...BNV...) (models PPF...BNV...) (models PPF...BNV...)
symbol, then press
" position).

operates the
The knob marked by the symbol
internal burner.
To turn on one of the rings, press the relative knob in
all the way and turn it anti-clockwise to the high setting
. The burner is fitted with an electronic igniter that
automatically starts when the knob is pressed in.
Since the burner is equipped with a safety device,
after lighting the burner keep the knob pressed in for
about 2-3 seconds to allow the device which keeps
the flame lit automatically to heat up.
The selected burner can be regulated using the
corresponding knob, as follows:
0 Off
Maximum
Minimum
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the ""/"

Practical advice on using the burners

To ensure the burners operate efficiently:
• Use appropriate cookware for each burner (see table)
so that the flames do not extend beyond the bottom
of the cookware.
• Always use cookware with a flat base and a cover.
• When the contents of the pan reach boiling point,
turn the knob to minimum.
Burner
A.Auxiliary
B.Semi-rapid
C.Rapid
D. Triple ring
I.Double ring DC-DR (inner)
I.Double ring DC-DR (outer)
To identify the type of burner, refer to the designs in
the section entitled, "Burner and Nozzle Specifications".
! Make sure the pans do not overlap the edges of the
hob while it is being used.
Note: for hob model B 30TC 138/CS BNV only
B 30TC 138/CS BNV model hobs are fitted with a
reducer shelf (see the figure below), which may only
be used in conjunction with the auxiliary burner "A".
operates the
" position).

ø Pan Diameter (cm)
6 – 14
15 – 20
21 – 26
24 - 26
10 - 14
24 - 28
21
GB