Start-Up And Use - SCHOLTES PP 40 DCDR F Serie Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25

Start-up and use

! The position of the corresponding gas burner or
electric hotplate is shown on every knob.
Gas burners
Each burner can be adjusted to one of the following
settings using the corresponding control knob:
0 Off
Maximum
Minimum
To light one of the burners, hold a lit match or lighter
near the burner and, at the same time, press down
and turn the corresponding knob anti-clockwise until
it reaches the maximum setting.
For models fitted with a safety device, the knob
should be held down for approximately 2-3 seconds,
until the automatic device keeping the flame alight
has heated up.
When using models with an ignition button, light the
desired burner by pressing down the corresponding
knob as far as possible and turning it anti-clockwise
towards the maximum setting, keeping it pressed
down until ignition has been achieved.
! Some models have a Double Flame burner. In this
case, to activate it, simply start by turning the knob
so that it is aligned with the
it all the way in and hold it in this position for
approximately 6 seconds, until the automatic device
keeping the flame alight has heated up.
! If the burner flame is accidentally extinguished,
shut off the control knob and wait for at least one
minute before attempting to light the burner again.
To switch off the burner, turn the knob in a clockwise
direction until it stops (position marked by the "0"
symbol).
The "independent double flame" burner:
The "independent double flame" burner:
The "independent double flame" burner:
The "independent double flame" burner:
The "independent double flame" burner:
This gas burner consists of two concentric flame
rings which can be used together or independently
of each other. Using both simultaneously at
maximum power makes it possible to reach a higher
overall power level, thus reducing cooking time with
respect to the time required by traditional burners.
The double flame ring also distributes heat more
evenly across the base of the pan, especially when
both burners are set to the minimum power level.
To ensure that the double-flame burner is used to its
full potential, never set the inside ring to minimum
and the outside ring to maximum at the same time.
Cookware of all sizes may be used; when cooking
with small recipients use only the inner burner. Each
individual ring with an "independent double flame
burner" has its own control knob:
symbol, then press
the knob marked with the symbol
outer ring;
the knob marked with the symbol
inner ring.
To light the desired ring, press the corresponding
knob fully in and turn it in an anticlockwise direction
until it reaches the maximum power position . The
burner is equipped with an electronic lighting
system which is activated automatically when the
knob is pressed.
As the burner is fitted with a safety device
As the burner is fitted with a safety device, the
As the burner is fitted with a safety device
As the burner is fitted with a safety device
As the burner is fitted with a safety device
knob should be held down for approximately 2-3
seconds, until the automatic device keeping the
flame alight has heated up.
Each burner can be adjusted to one of the following
settings using the corresponding control knob:
0
Off
Maximum
Minimum
To switch off the burner, turn the knob in a clockwise
direction until it stops (position marked by the "0"
symbol).
Practical advice on using the burners
To ensure the burners operate efficiently:
• Use cookware which is suited to each burner (see
table) in order to prevent the flames from
extending beyond the base of the pans.
• Always use cookware with a flat base and a cover.
• When the contents of the pan reach boiling point,
turn the knob to the minimum setting.
Burner
B. Semi-rapid
C. Rapid
D. Triple ring
I. DC-DR (inner)
I. DC-DR (outer)
! For models equipped with a reducer grid, the latter
must be used only for the inner Double Flame burner
(inner DCDR), when pans with a diameter of less
than 12 cm are used.
! Make sure the pans do not overlap the edges of
the hob while it is being used.
controls the
controls the
ø Cookware diameter (cm)
12 – 22
21 – 26
24 - 26
10 - 14
24 - 28
21
GB
GB
GB
GB
GB

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pp 40 dcdr sf seriePp 40 tc f seriePp 40 tc sf serieB pp 40dcdr/cs serieB pp 40dcdr serieB pp 40tc/cs serie ... Afficher tout

Table des Matières