SCHOLTES PP 40 DCDR F Serie Mode D'emploi page 15

Fig. 1
Fitting the hob to the cabinet Fitting the hob to the cabinet
Fitting the hob to the cabinet Fitting the hob to the cabinet Fitting the hob to the cabinet
There are three different groups of appliance as far
as installation is concerned:
BUILT-IN HOB
HEIGHT = STEEL THICKNESS
BUILT-IN HOB
STEEL THICKNESS <HEIGHT <77*/87**/90***mm
SUPPORTING SURFACE – ON HOB
HEIGHT > 77*/87**/90***mm
77* for models PP 40 TC F... - PP 40 TC SF... - B PP 40TC/CS...
87** for models PP 40 DCDR F... - PP 40 DCDR SF... - B PP 40DCDR/CS...
90*** for models B PP 40TC... - B PP 40DCDR...
Fig. 2
1 1 1 1 1 - Built-in hobs to be slotted in (Class 3 - see Figure
2, detail H1). In this case it is necessary to make
a hole in the worktop whose measurements match
those of the hob. The measurement at the side
should be reduced by 1 cm so as to ensure that 1
cm of the perimeter of the hob overlaps with and
rests on top of the supporting surface. To slot in
the hob flush with the worktop, the cut-out on this
supporting surface must be lowered (see Figure
4a), so that both the edge of the hob and the seal
underneath it can be positioned there. Before
fitting the hob to the worktop, position the seal
provided along the perimeter of the hob, as
illustrated in figure 4b. Brackets for fixing
worktops to the cabinet have been provided, and
these should be fitted as shown in detail S S S S S (fig.
3). . . . .
2 2 2 2 2 - Built-in hobs (Class 3) with edges lower than 77*/
87**mm (see Figure 2, detail H2); to install this
type of hob, a hole large enough to accommodate
the whole lower casing of the appliance must be
made in the worktop intended to be underneath
the hob. Remember to leave a gap of at least 1
cm between the lower casing and the worktop
around the whole perimeter of the appliance (the
underside of the casing can, however, touch the
surface below it). To fit the appliances, follow the
instructions given above in point 1 or use any
supplementary instruction leaflet that is provided
in special cases.
Fig. 3
GB GB GB GB GB
15