Waste Disposal - Beninca JM.3 Manuel D'instruction Pour L'utilisateur

User's handbook
Pull downward to carry out the
manual operation.
• Do not stand in the movement area of the door.
• Do not let children play with controls and near the door.
• Should operating faults occur, do not attempt to repair the fault but call a qualified technician.
To release the automatic system and manually operate the door, pull the knob P down. To reset to automatic
operation, push the lever L and send an opening or closing control signal to the automatic system.
If the height at which the system is fitted renders the level L difficult to reach, use another cord with knob.
• Every month check the good operation of the emergency manual release.
• It is mandatory not to carry out extraordinary maintenance or repairs as accidents may be caused. These
operations must be carried out by qualified personnel only.
• The operator is maintenance free but it is necessary to check periodically if the safety devices and the other
components of the automation system work properly. Wear and tear of some components could cause
dangers.
If the product must be dismantled, it must be disposed according to regulations in force regarding the dif-
ferentiated waste disposal and the recycling of components (metals, plastics, electric cables, etc..). For this
operation it is advisable to call your installer or a specialised company.
All Benincá products are covered by insurance policy for any possible damages to objects and persons
caused by construction faults under condition that the entire system be marked CE and only Benincá parts
be used.
P
Safety rules
Manual operation from the inside
Maintenance

Waste disposal

Warning
JM.3/JM.4
L
Push to reset the auto-
matic operating mode.
29